kleiner tgb 11 links
| C303 HOME Deutsch | C303 HOME English |
kleiner tgb 11 rechts

News: Board-Migration in progress, look at adminitrators-opinion

Willkommen, Gast. Bitte Login oder Registrieren.

  21.November 2026 19:57:32

Seiten: [1] Antwort Überwachen Senden Sie dieses Thema Drucken
   Autor  
All-Posts
 Thema: Washer pump systems - Windscreen & Headlights  (Gelesen 1961 mal)
WJM

**

Offline

Einträge: 4931





Profil anzeigen WWW eMail
Washer pump systems - Windscreen & Headlights
« am: 7.Juni 2008 23:18:21 »
Antwort mit Zitat nach oben
Sorry, noch einer....am Wochenende ist man ja am Faulsten....;))


The good part: my windscreen washer pump was not permanently stuck after all
(jammed, could very faintly hear the motor attempting, but not turning)

The bad part: removal was totally unnecessary, all it took was reversing the
current once, and the motor/pump was set free....8-))
(and it is a darn ugly position where this pump is mounted, especially given
this hindsight knowledge

Good part2: the grounding cable is mounted on the pump.
Bad part2: I tediously repaired it beforehand (connector torn off) on the stock
short piece of wire....would have been much easier to do with the pump off
(which I shouldn't have removed in the first place, remember?....;))

Good part3: I now have a working pump.
Bad part3: I still have no fluid coming out of either nozzle.
My naïve attempt to find the hose connector on the underside of the dash, right
were the nozzle is located, resulted in the baffling conclusion that there are
two layers of metal, no direct access to that darn thing from below (at least
not that I could see, not even feel (there is a 2cm diameter hole, on the left
side of the tunnel, but it would be a nightmare to get in there).
Now, I once saw the nifty trick to remove the steel spraying ball inside the
nozzle, on a Land Cruiser, but I forgot which tiny piece of strong metal they
used....a 0.5mm drill probably?
(a safety needle might not be strong enough?)


The good part4 (also in automotive historical context): I have the factory
headligh wipers & washers (I consider it utter decadence on what is basically a
military truck....:))
The bad part4: the right one wipes & sprays like it left the factory yesterday,
but the left washer system is dead as a doornail.
I recall the one-way valves in both systems (windscreen & headlights) are
notorious for breaking down....correct?
Any good replacement, factory or aftermarket?
And isany of the original valves more likely to fail than others?
Where do I start in that spaghetti-tubing?....:))


Btw one-way valves: I probably also found a nice & nifty solution to stop the
sustained gravity-feed from my cargo-room mounted fuel tank into the lower
factory tank, after the electric pump is shut off (unless you blow hard into
the factory vent line, or brake a few times very aggressively at higher speed
(to break the 'line of fluid'), it keeps flowing forever.
Solution: a one-way valve that is normally used in fuel lines, plastic, few
euro's....it has some initial resistance, before it opens....should be enough
to counter gravity....:))
(not sure yet whether it would restrict the electrical fuel pumping, but I
guess that such valves are also present in vehicles with similar (high-end)
pumps, so that should not likely be a problem)

(actually, I ordered one of those one-valves for brake bleeding, on the end of
the bleeding line, on the bleeding nipple (no need to tighten the bleeding
nipple when you let go of the pedal (although I still remember an old warning,
not to use vacuum bleeders, because the bleeding nipple at the wheel can leak
air through the screw thread....same scenario would occur with a one-way valve,
although a bit milder perhaps (no (strong) vacuum sucking downwards, only the
pedal movement upwards)


All comments, pointers, tips or tricks are welcome, before I entangle myself in
a spaghetti of washer tubing....:))
*Verkaufe Battery-Equalizer/Charge-Balancer/Wandler 24->12v/100A*


Those who wander are not necessarily lost
J.R.R. Tolkien
...and not all who launder are washed/WJ....;))


<w.j.markerink@A1.NL>
Moderator benachrichtigen   Gespeichert
WJM

**

Offline

Einträge: 4931





Profil anzeigen WWW eMail
Re:Washer pump systems - Windscreen & Headlights
« am: 8.Juni 2008 13:44:45 »
Antwort mit Zitat nach oben
Addendum:

Remember good part 'impeccable functional right hand headlight wiper & washer'?

Bad part today: the darn thing now has what my fuel tank used to have: gravity feed....sucked my washer bottle half empty over night, spilling it all through the wiper on bumper and into the ground....8-))

Pulled the headlight-washer-tube right at the T-splitter near the bottle, to break the 'line of fluid'....


Willem (starts hating the law of leveling fluid tanks) Jan
*Verkaufe Battery-Equalizer/Charge-Balancer/Wandler 24->12v/100A*


Those who wander are not necessarily lost
J.R.R. Tolkien
...and not all who launder are washed/WJ....;))


<w.j.markerink@A1.NL>
Moderator benachrichtigen   Gespeichert
Seiten: [1] Antwort Überwachen Senden Sie dieses Thema Drucken
Powered by MySQL Michaels-Volvo-Offroader-Forum | © 2001-2004 YaBB SE
forked to php5 & mysql-5 & XHTML in 2009 by mibu
lifted to php8.2 in 2024 by mibu
Powered by PHP

| Datenschutz | Impressum |

Seite erstellt in 0.0642 Sekunden. 19 Queries.