| Michaels-Volvo-Offroader-Forum | VOLVO C30x und Verwandte | C303/C304/C306 + TGB-11/13/20/1111 | « vorheriges Thema folgendes Thema » |
|
||||
Autor
|
Thema: Swedish Military Paint (Gelesen 2264 mal) | |||
| ||||
|
Hello Claas and other Members.
With the 1k top coats from http://www.militaerlacke.de/ do you need a hardener? I bought enough 4 colour paint to do my whole C304 but I am having trouble. (I am in the poopa!!!) The Instructions were in German and the emails claimed the paint was enamel when I found out the only thinners to work with the paint was acrylic thinners. Maybe the original thinners had hardener in it. The problem was I could not bring original factory thinners from the manufacturer into Australia with the paint shipment. My problem is that when I spray the the paint it does not harden (stays quite soft). Then when I spray the original matt coating over the new paint Iwould get a hard coat but it does not last in high UV Australian environment. Can any one advise me please-- or is willing to act as an interpreter to communicate with the manufacturer to see what is required for a suitable paint job. Johnny | ||||
johnny
|
||||
| ||||
|
Hi Jonny,
if you use, there should be no hardener inside the paint.The idea of 1K coatings normally is that the solvent evaporated. You normally don´t need hardener but time. If you need thinner ( for example 10% because you want to use a spray gun) it is very nimportant to use the right thinner. I think that is the problem. You have to use the thinner recommendet by militäarlacke. Without thinner the normal drying time is less than half an hour.The 1K coluer is synthetisch resin varnisch, only a preamble and not a clearly specification. So it should be possible your thinner is incompatible with the coating.What you can do to protect your coating from the sun: Use a 2K clearcoat to protect the colour. I personally would use u mat clear coat. Or better in the future use 2K coating from Militärlacke. For this you need hardener and probably thinner, but the lifetime (in the sun) is better. regards Claas | ||||
|
||||
| ||||
|
Hi Claas. I am using a spray gun(SATA) with 1.4mm needle.
Is the normal thinner dilution 10%? I tried that and the mixture seemed too thick compared to other Acrylic paints I sprayed in the past. Militarlacke Thinner can you verify it the thinner used for their 1K paint is Enamel (old terchnology) modern Acrylic.? Ioriginally tried a paint sample with local enamel thinner but the paint would not dissolve easily and started to coagulate. cheers Johnny | ||||
johnny
|
||||
|
||||
| Michaels-Volvo-Offroader-Forum | VOLVO C30x und Verwandte | C303/C304/C306 + TGB-11/13/20/1111 | « vorheriges Thema folgendes Thema » |









Autor








Gespeichert
If you need thinner ( for example 10% because you want to use a spray gun) it is very nimportant to use the right thinner. I think that is the problem. You have to use the thinner recommendet by militäarlacke. Without thinner the normal drying time is less than half an hour.The 1K coluer is synthetisch resin varnisch, only a preamble and not a clearly specification. So it should be possible your thinner is incompatible with the coating.