kleiner tgb 11 links
| C303 HOME Deutsch | C303 HOME English |
kleiner tgb 11 rechts

News: Board-Migration in progress, look at adminitrators-opinion

Willkommen, Gast. Bitte Login oder Registrieren.

  21.November 2026 05:48:19

Seiten: [1] Antwort Überwachen Senden Sie dieses Thema Drucken
   Autor  
Autor-Posts
 Thema: Wheels spacers?  (Gelesen 1606 mal)
Lucagoesoffroad

*

Offline

Einträge: 6



Ich liebe dieses Forum!

Profil anzeigen
Wheels spacers?
« am: 14.Februar 2024 06:54:17 »
Antwort mit Zitat nach oben
Good morning, I looked on Amazon, Aliexpress, Ebay, etc... but I can't find spacers that can fit the original c303 wheels. The size should be 8x222.5 mm or 8x8.75 inch, right? I've read somewhere about conversion kits to make it 6x139 like Toyotas, but that seems more complicated and expensive than spacers! Or am I missing something? Thank you very much
Moderator benachrichtigen   Gespeichert
Mo

**

Offline

Einträge: 349



Ich liebe dieses Forum!

Profil anzeigen
Re:Wheels spacers?
« am: 14.Februar 2024 17:16:9 »
Antwort mit Zitat nach oben
If you add spacers then you're increasing the distance between the steering pivot point and the centre of the wheel. This will negatively affect handling and cause premature bearing failure. Read here for more details: https://www.theautopian.com/our-suspension-engineer-tells-you-his-opinion-on-wheel-spacers/

Portal axles already have a large distance between the pivot point and the wheel hub. Volvo uses wheels with over 100% offset to compensate for this. Look at this photo:

The wheel nuts are not inside the wheel, they're beyond the outer edge of the tyre..

Maurice
Moderator benachrichtigen   Gespeichert
Lucagoesoffroad

*

Offline

Einträge: 6



Ich liebe dieses Forum!

Profil anzeigen
Re:Wheels spacers?
« am: 15.Februar 2024 08:6:12 »
Antwort mit Zitat nach oben
Right! I'm just afraid of rolling over a car 2.2m tall (2.5 with the roof top tent) with the tires so close to each other!
Moderator benachrichtigen   Gespeichert
kawahans

**

Offline

Einträge: 488



Ich liebe dieses Forum!

Profil anzeigen eMail
Re:Wheels spacers?
« am: 15.Februar 2024 09:2:36 »
Antwort mit Zitat nach oben
Hello!
These considerations exist and have been discussed many times (including here in the forum). But if you draw a force diagram with the data from the C303, you can immediately see that the effect of 3 or 4 cm spacers is practically zero. In dangerous areas, at least keep the lower tires at full pressure to minimize buckling. If necessary, reduce the spring rate with adjustable bump stops.

Kind regards from Graz!
kawahans
1314 - weil er so schön ist
Moderator benachrichtigen   Gespeichert
WJM

**

Offline

Einträge: 4931





Profil anzeigen WWW eMail
Re:Wheels spacers?
« am: 15.Februar 2024 09:54:9 »
Antwort mit Zitat nach oben
fHmmm....first analytical question would be:

Worried about offroad/low-speed, or onroad/high-speed?

(both is also valid of course, but not every possible (exotic) remedy can be applied to both situations (equally))

Some brainstorming ponderings:

- More evenly distributed weight, read more load in the rear (when emergency braking at higher speed, the last push for a roll can be a very tiny bump, if all wheel travel is gonealready, read you already hit the bumpstops, hard)

- distribute weight dynamically, by pumping water (or fuel) from one belly-side-tank to the other....:))
(SWB only allows about 75L/kg, but still....;))

- air-springs, with manual override, side-shifting pressure

- Instead of (or additional to) pushing up the low side, you could also pull down the high side, by cable....small winch seems complicated, but an electric scissors jack-lift might not....:))
(this is also one of my contemplations for lifting the entire rear-most axle of a 6x6, to decrease the turning radius (you can't push the middle axle down instead, as it would make the spring-ends fall out of their axle-sockets)
(note that the rear=most axle doesn't have to be up in the air entirely; any significant weight shift will change/improve the turning radius, almost exponentionally)
(just like throwing sand under the rear-most wheels, now that I think about it....:))))
(onroad-only, of course, sadly....;((
(thanx for the inspiration either way....:))

- make your roof rack/tent shiftable, side-shift on telescopic rails; manually or electric/pneumatic (hydraulic would add even more weight....;))

(this concept could be synergised by having a shallow cargorack underneath the tent, fixed to the roof, so when camping/stationary, move rooftent out to side, full access to cargo compartment; also more/larger shelter/living space under the tentfloor
(a la classic AutoCamp Family)
(2x2m)


<ADDENDUM>

- Side-shifting telescoping roofrack-rail water tank/tube (water only pumped in & up when needed, cq normally in bottom/belly tank)
(side-note: none of these side-shifting telescope concepts can work in very tight terrain/forest of course, but at say 45 degree tipping angle, you should have at least 1m side-sway on the high-side, roof-height....:))

Well, even just pondering about all this, cracking your brain, will prevent you from driving & subsequent roll-over risks....so even just on paper all this is already beneficial....;))))

*Verkaufe Battery-Equalizer/Charge-Balancer/Wandler 24->12v/100A*


Those who wander are not necessarily lost
J.R.R. Tolkien
...and not all who launder are washed/WJ....;))


<w.j.markerink@A1.NL>
« Letzte Änderung: 15.Februar 2024 19:31:42 von WJM » Moderator benachrichtigen   Gespeichert
Seiten: [1] Antwort Überwachen Senden Sie dieses Thema Drucken
Powered by MySQL Michaels-Volvo-Offroader-Forum | © 2001-2004 YaBB SE
forked to php5 & mysql-5 & XHTML in 2009 by mibu
lifted to php8.2 in 2024 by mibu
Powered by PHP

| Datenschutz | Impressum |

Seite erstellt in 0.054 Sekunden. 21 Queries.