| Michaels-Volvo-Offroader-Forum | VOLVO C30x und Verwandte | C303/C304/C306 + TGB-11/13/20/1111 | « vorheriges Thema folgendes Thema » |
|
||||
Autor
|
Thema: Washer pump systems - Windscreen & Headlights (Gelesen 1960 mal) | |||
| ||||
|
Sorry, noch einer....am Wochenende ist man ja am Faulsten....;))
The good part: my windscreen washer pump was not permanently stuck after all (jammed, could very faintly hear the motor attempting, but not turning) The bad part: removal was totally unnecessary, all it took was reversing the current once, and the motor/pump was set free....8-)) (and it is a darn ugly position where this pump is mounted, especially given this hindsight knowledge Good part2: the grounding cable is mounted on the pump. Bad part2: I tediously repaired it beforehand (connector torn off) on the stock short piece of wire....would have been much easier to do with the pump off (which I shouldn't have removed in the first place, remember?....;)) Good part3: I now have a working pump. Bad part3: I still have no fluid coming out of either nozzle. My naïve attempt to find the hose connector on the underside of the dash, right were the nozzle is located, resulted in the baffling conclusion that there are two layers of metal, no direct access to that darn thing from below (at least not that I could see, not even feel (there is a 2cm diameter hole, on the left side of the tunnel, but it would be a nightmare to get in there). Now, I once saw the nifty trick to remove the steel spraying ball inside the nozzle, on a Land Cruiser, but I forgot which tiny piece of strong metal they used....a 0.5mm drill probably? (a safety needle might not be strong enough?) The good part4 (also in automotive historical context): I have the factory headligh wipers & washers (I consider it utter decadence on what is basically a military truck....:)) The bad part4: the right one wipes & sprays like it left the factory yesterday, but the left washer system is dead as a doornail. I recall the one-way valves in both systems (windscreen & headlights) are notorious for breaking down....correct? Any good replacement, factory or aftermarket? And isany of the original valves more likely to fail than others? Where do I start in that spaghetti-tubing?....:)) Btw one-way valves: I probably also found a nice & nifty solution to stop the sustained gravity-feed from my cargo-room mounted fuel tank into the lower factory tank, after the electric pump is shut off (unless you blow hard into the factory vent line, or brake a few times very aggressively at higher speed (to break the 'line of fluid'), it keeps flowing forever. Solution: a one-way valve that is normally used in fuel lines, plastic, few euro's....it has some initial resistance, before it opens....should be enough to counter gravity....:)) (not sure yet whether it would restrict the electrical fuel pumping, but I guess that such valves are also present in vehicles with similar (high-end) pumps, so that should not likely be a problem) (actually, I ordered one of those one-valves for brake bleeding, on the end of the bleeding line, on the bleeding nipple (no need to tighten the bleeding nipple when you let go of the pedal (although I still remember an old warning, not to use vacuum bleeders, because the bleeding nipple at the wheel can leak air through the screw thread....same scenario would occur with a one-way valve, although a bit milder perhaps (no (strong) vacuum sucking downwards, only the pedal movement upwards) All comments, pointers, tips or tricks are welcome, before I entangle myself in a spaghetti of washer tubing....:)) | ||||
|
*Verkaufe Battery-Equalizer/Charge-Balancer/Wandler 24->12v/100A* Those who wander are not necessarily lost J.R.R. Tolkien ...and not all who launder are washed/WJ....;)) <w.j.markerink@A1.NL>
|
||||
| ||||
|
One of my windscreen washer jets stopped up, the passenger side. I find that usualy this sort of thing can be cleared with a pin or sowing needle. It resisted my first attempt, so my better half gave some assistance and after emptying the water bottle a couple of times we had a feeble dribble. I had to precariously leaver my arm through the open door and power the water switch, I'm 5' 6",
while I held my finger against the good drivers side nozzle, increasing the power to the other jet, squirting eventually splashed me from the none operating and know miss directed orifice. The only thing was the drivers side started to play up and the passenger side was almost impossible to line up with the correct screen.I looked underneath the dash to see if I could detach the nozzles and pt them back again but they could not be seen. I suspect that one prizes them out and pulls on the pipework but I did not trust my self, thinking I would extract them then would become stuck with protruding eye balls like in a cartoon. After more effort, constant adjustments i had full force on both screens and a very soaked me. I beleive that their is a special tool desighned for clearing and aiming washer jets, I saw it once a couple of years ago but I always nick Jo's sowing needles. I guess the special tool would be better shaped. I fancy having the washers come off the wiper arms but I guess that they would freeze up in the winter time. | ||||
|
Grüße Anthony GB
|
||||
| ||||
|
Addendum:
Remember good part 'impeccable functional right hand headlight wiper & washer'? Bad part today: the darn thing now has what my fuel tank used to have: gravity feed....sucked my washer bottle half empty over night, spilling it all through the wiper on bumper and into the ground....8-)) Pulled the headlight-washer-tube right at the T-splitter near the bottle, to break the 'line of fluid'.... Willem (starts hating the law of leveling fluid tanks) Jan | ||||
|
*Verkaufe Battery-Equalizer/Charge-Balancer/Wandler 24->12v/100A* Those who wander are not necessarily lost J.R.R. Tolkien ...and not all who launder are washed/WJ....;)) <w.j.markerink@A1.NL>
|
||||
|
||||
| Michaels-Volvo-Offroader-Forum | VOLVO C30x und Verwandte | C303/C304/C306 + TGB-11/13/20/1111 | « vorheriges Thema folgendes Thema » |









Autor








Gespeichert
while I held my finger against the good drivers side nozzle, increasing the power to the other jet, squirting eventually splashed me from the none operating and know miss directed orifice. The only thing was the drivers side started to play up and the passenger side was almost impossible to line up with the correct screen.