| Michaels-Volvo-Offroader-Forum | ALLGEMEINES | Ersatzteile / Parts / Replicas / Links | « vorheriges Thema folgendes Thema » |
|
||||
Autor
|
Thema: Wanted Passenger Seat rail (Gelesen 1988 mal) | |||
| ||||
|
Has any member a spare passenger seat rail frame they can sell me?
Hat jedes Mitglied eine freie Personenverkehr Bahn Sitzrahmen kann sie mir verkaufen? | ||||
johnny
|
||||
| ||||
|
I used Google Chrome translator built into Browser. You should see the German translation to English.
Especially Kay's posting it it makes me confused The Passenger Rail I need is the fixed one that has a bolt on the rail so that the rail can be slid back and rebolted into position. This is not the easiest however due to fact the bolt is on the inside rail close to Engine compartment. Thanks for your Correct Translation. | ||||
johnny
|
||||
| ||||
|
Thanks WJM, My TGB13 is the military LHD version. You obviously have experience in modification of the seat rails and yes it is rather cramped unless you can move the seats further back---you can't have everything.
On the subject of seat position comfort -do you find the angle of your foot is in an acute angle-- difficult position to operate the throttle? I found I had to use a block of wood under the rubber mat to rest my heel on as the normal position gave me cramps after a short while driving.The drivers side is Ok for me as I am 6ft tall, but the passenger is my 6ft 3" son. The original rail I need will be set at it furthest rear position and locked there so I don't need the adjustable one but if one is available I can modify. I retro-fitted bucket seats and modified the original rails to mount them, but the extra height of bucket seat on passenger side is the issue. I want go back to original passenger side as this will reduce the height and not foul on the Donaldson Truck air filter housing I have behind the passenger seat. I am sure that there must be some rails available on spare cabins that have been removed. | ||||
johnny
|
||||
| ||||
|
" What still could be tempting, is modifying the wheel well in that particular spot, by cutting out the size of your heel, and 'squaring' it down, so that you have about 5cm more room to the rear of your heel.
Good suggestion WJM. I had seen this done some time ago.I am not sure if it was posted on this forum or a partial cabin rebuild from Finland that was pre ALUZINC. | ||||
johnny
|
||||
|
||||
| Michaels-Volvo-Offroader-Forum | ALLGEMEINES | Ersatzteile / Parts / Replicas / Links | « vorheriges Thema folgendes Thema » |









Autor








Gespeichert
Especially Kay's posting it it makes me confused
I found I had to use a block of wood under the rubber mat to rest my heel on as the normal position gave me cramps after a short while driving.
I am sure that there must be some rails available on spare cabins that have been removed.