Hi -
a few questions which might help to understand / isolate the problem / cause:
1. Are the donations occur rather in the intake manifold than in the exhaust / flam-tube part?
2. Do the detonations occur whilst pressing the throttle (accelerating) or rather whilst releasing after acceleration?
3. Is the vacuum advance for the distributor timing (vacuum supplied by a small tube and screw on the front carburettor) functional and set?
4. Is the damper oil in both carburettors filled up correctly?
|
Omg didn’t see that response so sorry!
Detonations are in the intake (80% sure) and occur only when accelerating in that kind of situations when you want to push more but the motor can’t for example when you are low rpm in large gear and try to accelerate, it’s like the excess of gas is not properly managed.
O have check visually the vacuum tube visually and seems to be ok.
The oil level of the rear carburador seems to be ok (covers all the centre spindle. But the front carburettor seems to have insufficient oil. I push the spindle and gets out dry.
Could be caused by this? It only happens when the engine is hot (temperature never goes over 90) but after a lot of km at a fast speed. Never doing offroad.
How can I fill it? I mean, I suppose I can’t put too much inside, I’m afraid of puttin in too much.