| Michaels-Volvo-Offroader-Forum | SPEZIELLE THEMEN | Antriebskraft / power | « vorheriges Thema folgendes Thema » |
|
||||
Autor
|
Thema: Stainless steel exhaust (Gelesen 2407 mal) | |||
| ||||
|
I didn't find any discussion here. Is it prohibited by TUV?
Can someone explain how these pipes connect together? It's not like the original, which has bolts and gaskets. ![]() Similiarly, what is the purpose of the flexible pipe here? Is it just a lazy way to attach to the original downpipe? ![]() I read a horror story where trying to attache a new downpiperesulted in a broken manifold. https://www.c303.de/c303-forum/index.php?board=36;action=display;threadid=14287;start=msg122673#msg122673. Is this a common problem when changing the exhaust? ![]() Lastly, can anyone see a problem if the tailpipe is directed to the right side instead of the left? As we drive on the left here, blowing to the left isn't very pedestrian friendly, especially at C303 height ![]() Thanks, as always Maurice | ||||
|
||||
| ||||
|
The connection between the pipes seems to be with clamps for me. Nothing unusual. The flexible pipe is an improvement, I think, because it allows the exhaust to flex :-)
Edit: infinity-exhausts.co.uk? Never heard about them. How much is the exhaust? I bookmarked https://rakaror.o.se/BilderVolvoEdelstahlAuspuffanlagen.htm for me. Edit: The horor story was that the manifold rusted away, appearantly due to the usage of exhaust heat protection tape on the manilfold, which drew and saved water. | ||||
|
||||
| ||||
|
You don't need all this spaghetti, *double* frame-crossing, *and* two big mufflers.
Keep the exhaust inside the frame, put a single (smaller-diameter) muffler near the diff, and let the end pipe either go down, or to the (right) side (the latter is a bit complicated with 4x4, being that the leaf spring hanger is in the way, so you might have to do a 'U-turn' there). (on 6x6, even more so LWB (C306/TGB20), the routing is much more relaxed & straightforward) (some 6x6/LWB firetrucks even had it routed all the way to the back, but the (stainless-steel) muffler shop I had mine done looked at that only briefly, and said: nightmare, many sharp turns, multiple frame-crossings, up and over. Bonus: improved engine-sound also....:)) And: no overheated feet for rear seat passengers on the right....;)) | ||||
|
*Verkaufe Battery-Equalizer/Charge-Balancer/Wandler 24->12v/100A* Those who wander are not necessarily lost J.R.R. Tolkien ...and not all who launder are washed/WJ....;)) <w.j.markerink@A1.NL>
|
||||
| ||||
Clamps? I've never had an exhaust like that before, only with flanges and gaskets... The first picture is from rakaror, they are my preference too I have no experience with infinity-exhausts.co.uk, it's a Google result. They list this as a custom exhaust for a "rare Swedish military vehicle" I asked only because theirs has the flexible pipe where the original and rakaror exhaust do not. Earlier today I found another example of a flexible connection, ironically here at c303.de, but not in the forum - on the diesel conversion page. I guess a diesel vibrates more than a petrol? It also shows what I assume are the clamps you mentioned?![]() Thanks for the confirmation about the manifold. Reading the thread I wasn't sure if the problem was caused by the downpipe being taped, by the new downpipe not fitting correclty, or just old age. Probably all three now that I think about it
I found an example where the exhaust exits on the right. As you suggest they put a single muffler, but still outside the frame. I assume a single muffler will be noisier? I'm not sure that's a good idea. As someone recently wrote here, in a C30X speed isn't measured in kph or mph but in dB Maurice | ||||
|
||||
| ||||
|
...regarding exhaust on the right I shamelessly ponint to one of my videos: https://www.youtube.com/watch?v=SJttIdc8wic
Right at the beginning you see a solution. Edit: And here (timestamp) https://youtu.be/SJttIdc8wic?t=246 | ||||
|
||||
| ||||
|
That looks like fun, except for the guy in the 202. Hopefully one day I'll be able to join you in Germany
![]() When I need an new exhaust, and it will be sooner rather than later, I will ask rakaror if they can make one with the last turn to the right instead of the left. That will probably save on shipping too ![]() Maurice | ||||
|
||||
|
||||
| Michaels-Volvo-Offroader-Forum | SPEZIELLE THEMEN | Antriebskraft / power | « vorheriges Thema folgendes Thema » |









Autor










Gespeichert


I have no experience with infinity-exhausts.co.uk, it's a Google result. They list this as a custom exhaust for a "rare Swedish military vehicle"
I asked only because theirs has the flexible pipe where the original and rakaror exhaust do not. Earlier today I found another example of a flexible connection, ironically here at c303.de, but not in the forum - on the diesel conversion page. I guess a diesel vibrates more than a petrol? It also shows what I assume are the clamps you mentioned?