| Michaels-Volvo-Offroader-Forum | ALLGEMEINES | Ersatzteile / Parts / Replicas / Links | « vorheriges Thema folgendes Thema » |
|
||||
Autor
|
Thema: Leaf springs (Gelesen 2212 mal) | |||
| ||||
|
Taking measurements of my vehicle (see https://www.c303.de/c303-forum/index.php?board=1;action=display;threadid=14803) I've realised that it leans towards the driver's side. The top of the front bumper on the passenger side is 94.5cm, on the driver's side it's only 91cm. Measurements between the stop plate and the hollow spring are similar, approx 5cm on the passenger side but only 3cm on the driver side.
I assume I have to replace my front springs. A set from Tatanka will cost at least £650 (€750) Any alternate sources you would recommend? In a thread from 18 months ago (https://www.c303.de/c303-forum/index.php?board=35;action=display;threadid=14079) the German company https://www.federfachman.de is mentioned. Does anyone have any experience with them?Thanks Maurice | ||||
|
||||
| ||||
|
The parts catalogue lists only one number for the front springs indicating that the left and right springs are identical. So it's perhaps expected that my vehicle leans to the left as it probably often had a driver but no passenger. I also suspect that the batteries are heavier than the muffler and heater combined.
Questions:
Thanks Maurice | ||||
|
||||
| ||||
|
Aha! I realised that the spring specifications are in the workshop manual. So a local manufacturer should be able to construct springs that are both the correct size and the correct strength without too much difficulty.
Yes. Each leaf is 3 inches wide (76mm) and 9/32 inch thick (7mm). I'm confident that any UK spring builder serving the vintage car market will have such material available as this size was once common here. So this may be a cost-effective solution for all of us ![]() I will contact the local manufacturer just as soon a I've rebuilt my wiper motors (it's illegal to drive without wipers) and update everyone here with my findings. Thanks Maurice | ||||
|
||||
| ||||
|
Can anyone tell me the spring bush size/measurements (for a 4x4)? I'd rather not unbolt a spring just to take measurements.
Also, is it usual to use new spring bolts when replacing springs? Thanks Maurice | ||||
|
||||
|
||||
| Michaels-Volvo-Offroader-Forum | ALLGEMEINES | Ersatzteile / Parts / Replicas / Links | « vorheriges Thema folgendes Thema » |









Autor






Any alternate sources you would recommend? In a thread from 18 months ago (
Gespeichert
but a manufacturer/supplier. There are of course leaf spring manufacturers here in the UK, and I found one (